COMPLETE SYSTEM DESIGN FROM DESIGN INCEPTION TO SMALL SCALE MANUFACTURING

We design and develop new, innovative electronic hardware-software-firmware products right from framing initial design concepts, prototype development, Testing and Verification, pre-production stage development, small scale manufacturing and support. All of this work is either conducted in-house by our technologists and electronic engineers, specialists or through our most trusted and renowned channel partners. This makes everything very efficient, quality controlled, reliable, innovative, enabling us to offer a rapid development service.

SOME OF THE DEVELOPED SYSTEMS ARE AS FOLLOWS:-

• Accelerator and Control Systems / Modules / Cards
• Nuclear Systems / Modules / Cards
• Defense Systems / Modules / Cards
• 8 Channel RF Down Converter for converting 650 MHz RF signal from Cavity to 20 MHz base band signal to be used for Control in Low Level RF Systems for Accelerator Control Applications.
• Dual Xilinx FPGA based Mass Storage Interface Module that interfaces as a bridge between Mother Board and both mass storage devices such as SATA 2.0 HDD and USB 2.0 storage Devices that can fit in 5-1/4” bay in COTS used in Defence Application.
• Dual Xilinx FPGA based Time Stamping Hardware developed for High resolution time stamping & counting of input logic pulses and for Analog Data Acquisition for Nuclear applications.
• FPGA and ARM Cortex M3 based Nuclear Detector type Pulse Signal Generator for Nuclear Instrumentation Calibration Applications.
• Hardwired Safety Class 1A Reactor Power Set Back Modules for Nuclear Application During Nuclear Reactor Power Setback.
• ARM Cortex M3 based Characteristic Impedance Meter for Characterization of Coaxial Cables from 50 ohm to 93 ohm from 1 MHz to 100MHz.
• Design and development for Linear Neutron Flux generation and Online Reactivity measurement – NRHO for Nuclear Submarine application.
• FPGA and ARM cortex A8 controller based Neutron Power Module for Nuclear Instrumentation Application.
• Hardwired Prototype Reactor Power Set Back Module for IGCAR
• FPGA based Cover Gas Monitor Data Analysis Module for IGCAR.
• Design and Development of FPGA based Online Reactivity Meter with Online Diagnostic Features.
• Design and Development of Scalar and Timer using FPGA.
• Design and Development of FPGA based Vernier Power Meter.
• Design and Development of FPGA based Online linearly and exponentially increasing pulse frequency signal for testing LCRM and Scalar and Timer.
• Design and Development for FPGA based Log Calculator for LCRM using several Mathematical Algorithms.
• Design and Development of FPGA based Online Neutron Flux Simulator using RK4 method for testing Reactivity Meter.
• Development of Algorithm and Characterization of FPGA based Campbell meter used for RMS power calculation using FFT.